bracelet manchette Marilyn bubble effet 3D

Bracelet résine imprimé double face (intérieure et extérieure)
création graphique unique by Juste une impression inspirée de la robe coordonnée (cf visuel)
édition ultra limitée.
Si rupture de stock fabrication unitaire sur commande (délai maximal 2 semaines).
Taille unique réajustable sans altération de l'impression, pelliculage vernis de surface (cf notice ci-dessous).
dimensions :
hauteur 4 cm
largeur 15 cm
 
-----
 
Double-sided printed resin strap (inside and outside)
unique graphic creation by Just an impression inspired by the coordinated dress (cf visual)
ultra limited edition.
If out of stock, make-to-order production (maximum lead time 2 weeks).
 
One size fits all without altering the print, surface varnish lamination (see instructions below).
dimensions :
height 1.57 inches
width 5.9 inches
 
 
How to adjust the bracelet to your wrist
the bracelet is too tight or too wide for your wrist, no problem!
prepare a bowl of cold water on the side
boil water (avoid the kettle or the microwave, but use the saucepan).
plunge the bracelet completely out of the fire for 10 to 15 seconds maximum to make it malleable.
remove the bracelet and take it off with gloves so as not to burn yourself.
you can then tighten or open it by moving each end symmetrically towards or away from each other to preserve the converse shape of each bracelet.
once the desired measurement has been obtained, immerse the bracelet in the bowl of cold water prepared to freeze the new shape/size.
Try the bracelet again once it has been wiped and cooled.
If the new measurement is not suitable, repeat the complete operation until the required size is reached.
This operation, even if repeated, is without any risk for the bracelet or for the original colours (no alteration of the material (resin), varnish or original colours).